Experiments with Two Queen Colonies


Soon after I started beekeeping, a visiting American apiarist showed me a set of photo's showing how they had hived a swarm above an existing colony, by replacing the crown board with a floor and replacing the crown board and roof above the dual hive. The advantages given for this was that only a floor and brood box were required.

Later on, I saw a '2-Queen board' (2QB) illustrated in Ron Brown's book "Beekeeping - A Seasonal Guide". The 2QB is adapted from a crown board, lipped on both top and bottom, with an side entrance cut in the top lipping. The two feedholes are covered top and bottom with perforated zinc or other wire gauze, so no bee could make contact through the gauze.

Another hole is cut through the centre of the board, The underside of this hole is covered with a piece of zinc Queen excluder, whilst on the top a pivoted sheet of metal is arranged so that it could either cover or open the access to the queen excluder. A wire is led from the sheet metal through the side so that it can pull the metal to move it from covering the hole to exposing the queen excluder. (See diagram).

His technique involved making an artificial swarm and installing this on top of the 2QB above a super on the original colony. The advantages of this manoeuvre were greater brood production with the two queens in full lay and thus an increased harvest. When the two colonies were united at the end of the flow the younger queen would normally survive and so there would be automatic re-queening.

In use the two colonies are installed one above the other with at least one super between the two brood boxes, the lower brood box having its usual queen excluder. The metal plate is left closing access to the lower hive and the colonies are left thus for several days so that they can get used to the different colony smells via the ventilation holes in the 2QB.

The wire is then pulled opening access to the queen excluder and the workers of the two colonies can mingle and store honey jointly in the available space. When required, a queen excluder is placed above the top brood box and supers placed above it.

My first experiment took place some years ago, when I took a swarm and had no space for a further colony in my apiary. So the swarm was duly installed over the 2QB and the colonies left to get used to each other for a couple of days.

Bees were happily flying from both the top and bottom entrances when I pulled the wire. This, unfortunately, was the signal for war to be declared; and the next morning both the floorboard and the 2QB were covered in dead bees, masses of them. The experiment had to be considered a failure and the 2QB was consigned to the depths of the bee shed.

This year the circumstances were rather similar, I had to remove a swarm from the boiler house of a friend. I had no available space for another colony. I decided to try the 2QB again; once more the swarm was installed, on foundation, above an established colony, this time with two supers between the brood boxes. The opening plate was left closed and……….. I went off to Gormanstown.

On my return the swarm had done a lovely job of drawing out all the frames in the upper brood box and I decided it was time to let the two colonies make closer acquaintance.

The wire was pulled in the evening and with trepidation I visited the colony the next day. This time there were no heap of corpses to greet me, the bees were flying happily from both entrances and all seemed well in the world.

There was, however one slight drawback to the whole scheme, the main honey flow had occurred whilst I was at Gormanstown and the two colonies had been separated during that period. I did get a brood box of frames fully drawn and two supers full to the brim of honey.

In conclusion, I have found that it is absolutely necessary for the bees to have a long period for the hive scents to mingle before mixing of the stocks. The week of Gormanstown was certainly long enough, the three days of the earlier experiment was clearly too short.

Ruary Rudd

Social

News

Gormanston 2017!

The provisional programme for Gormanston 2017 is now available.This years Gormanston will be taking place from 30th of July - 4th August! We have a series of great talks and workshops for all levels, from beginners to intermediate and senior. Check out the programme of events and book your place before places run out!

Please note that this may be subject to future changes so keep checking back to get the most up today information!


COLOSS Survey 2017!

The annual COLOSS survey on winter colony losses is now available for completion online by clicking the link: https://tinyurl.com/mapfgof

Closing date is 1 June 2017

Please participate…Thank you


Hedge cutting

If you wish to report hedge cutting out of season
Contact the people below
National Parks & Wildlife Service
7 Ely Place
Dublin 2
IRELAND D02 TW98
For General Queries:
Tel: +353-1-888 3242
LoCall 1890 383 000 (within Republic of Ireland only - rates charged for the use of 1890 numbers may vary among different service providers)
Fax: +353-1-888 3272
E-mail: nature.conservation@ahg.gov.ie
Web: www.npws.ie


Disease Sampling Form

Teagasc offers a Honeybee disease diagnostic service to beekeepers, more information available here


Bee Research Project!

FIBKA are co operating with CIT to run a beehealth project to improve the genetic diversity of Irish honey bee stocks, funding needed either corporate or individual. Click here for more info!


All-Ireland Pollinator Plan

Great news! - The All-Ireland Pollinator Plan 2015-2020 is released this week. Click here for more info!


Got something to say!?

We are looking for people to submit articles on beekeeping or anything related to it, on a once off or a regular basis. If you think you could put pen to paper, then please email the Beachaire Manager, Dermot O'Flaherty at  manager.beachaire@irishbeekeeping.ie